Smeg FAB5RUJ Bedienerhandbuch PDF herunterladen (Seite 6)

Instructions for the Installer

3. INSTALLATION AND CONNECTION

3.1 Choosing the site

Always place the refrig

erator in a dry place with satisfactory ventilation. Never expose it to direct sunlight

or install it outdoors.

Depending on its climate class (stated on the nameplate inside the refrigerator

compartment), the appliance can be used in different temperature conditions:

Class Ambient temperature

SN (Subnormal) from + 10° C to + 32° C

N (Normal) from + 16° C to + 32° C

ST (Subtropical) from + 18° C to + 38° C

T (Tropical) from + 18° C to + 43° C

Never place the refrigerator close to heat sources.

If this is unavoidable, a suitable insulating panel must

be used to allow the appliance to function properly. Otherwise, place the appliance at least 3 cm from

electric or gas cookers and at least 30 cm from combustion or radiation heating systems.

allow proper cooling of the condenser, the refrigerator must not

be placed too close to the wall. To prevent this, the appliance

comes complete with two plastic spacers fitted at the top of the

condenser.

If the refrigerator is installed underneath a wall

cupboard, the distance between the two must be at least 5 cm.

Position the refrigerator so that the door can be opened fully.

Take care not to scratch or damage the floor when installing the

appliance on parquet or linoleum. If necessary, when positionin

slide the refrigerator over pieces of wood or a mat to the point

decided for connection to the electrical mains.

3.2 Positioning and levelling the appliance

Place the refrigerator on a firm, level surface.

To compensate for

any unevenness in the floor

, the refrigerator has four adjustable feet.

This gives it added stability and makes it easier to move around and

position. Take great care

when moving the appliance not to

damage the floor (for example, when installing on a parquet floor).

3.3 Electrical connection

Connect the appliance's power supply lead to a mains socket with earth contact, installed in accordance

with electrical safety regulations. The rated voltage and frequency are stated on the nameplate inside

the refrigerator compartment. The

appliance must be connected to the electrical mains and earthed in

compliance with the relevant regulations and requirements. The appliance is able to withstand short

fluctuations in voltage of no more than 15% less or 10% more than the rated voltage state

d on the

nameplate. If the power supply lead has to be replaced, this operation must only be carried

out by an

authorised Smeg technical service engineer.

The power plug must be accessible after the appliance

has been installed.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Smeg FAB5RUJ Bedienerhandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kühlschränke Smeg FAB5RUJ