Smeg SIMU530B Installationshandbuch PDF herunterladen (Seite 3)

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

■ Tape measure

■ Flat-blade screwdriver

■ Phillips head screwdriver

■ Hand or electric drill

■ Level

Parts supplied

■ Brackets (2)

■ 2¹⁄

" (6.4 cm) clamping screws (4)

■ #8 x ³⁄

" (9.5 mm) sheet metal screws (4)

Parts needed

■ A UL listed or CSA approved strain relief

■ UL listed wire connectors

■ A UL approved junction box or 240V outlet

■ Cooktop Bracket Adhesive Kit Part Number W10310006

if installing the cooktop into a marble countertop. See the

“Assistance or Service” section of the Use and Care Guide

for information on ordering.

Check local codes. Check existing electrical supply. See

“Electrical Requirements.”

It is recommended that all electrical connections be made by a

licensed, qualiﬁed electrical installer.

Location Requirements

Make sure you have everything needed for correct installation. It

is the responsibility of the installer to comply with the installation

clearances speciﬁed in these instructions.

IMPORTANT: Observe all governing codes and ordinances.

When installing cooktop, use minimum dimensions given.

■ To eliminate the risk of burns or ﬁre by reaching over the

heated surface units, cabinet storage space located above

the surface units should be avoided. If cabinet storage is to

be provided, the risk can be reduced by installing a range

hood that projects horizontally a minimum of 5” (12.7 cm)

beyond the bottom of the cabinets.

■ It is the installer’s responsibility to comply with installation

clearances speciﬁed on the model/serial rating plate. The

model/serial rating plate is located on the underside of the

cooktop burner box.

A.Model/serial rating plate location

■ Marker or pencil

■ Pliers

■ ¼" drill bit

■ Jigsaw

30" (76.2 cm) cooktop model/serial rating plate

location (model SIMU530)

36" (91.4 cm) cooktop model/serial rating plate

location (model SIMU536)

A.Model/serial rating plate location

■ Check the cooktop base for an approved installation label.

Verify approved oven model numbers that can be installed

with your cooktop model number. If you do not ﬁnd this

label, your cooktop may not be approved for use over an

undercounter built-in oven. Contact your dealer to conﬁrm

that your cooktop is approved.

■ Ovens approved for this type of installation will have an

approval label located on the top of the oven. If you do

not ﬁnd this label, contact your dealer to conﬁrm that your

oven is approved. Refer to oven manufacturer’s Installation

Instructions for approval for built-in undercounter use and

proper cutout dimensions.

■ When installing cooktop over an undercounter built-in oven,

do not fasten cooktop to countertop with clamps or seal

cooktop to countertop. This will make the cooktop easier to

remove if future servicing becomes necessary.

■ Use the countertop opening dimensions that are given

with these Installation Instructions. Given dimensions are

minimum clearances and provide 0” (0 cm) clearance.

■ Grounded electrical supply is required. See “Electrical

Requirements” section.

1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare

Smeg SIMU530B Installationshandbuch Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Smeg SIMU530B