Smeg CIR574X Bedienerhandbuch

Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE ______________________ 4 2. POSITIONING OF THE HOB ______________________________________ 6 3. G

Instructions for the installer 12 5. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appl

Instructions for the installer 13 5.2 Adjustment for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle

Instructions for the installer 14 5.3 Adjustment for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the u

Instructions for the installer 15 6.2 Arrangement of burners on the hob Burners 1 Auxiliary 2 Semi rapid 3 - 6 Rapid 4

Instructions for the user 16 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitte

Instructions for the user 17 7.2 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered conta

Instructions for the user 18 7.4 Electric elements 7.4.1 Turning on electric elements Hobs may be fitted with an electric element of varying dia

Instructions for the user 19 WARNING When switching on the electric element for the first time, or if the electric element has not been used for a

Instructions for the user 20 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning

Instructions for the user 21 8.3 Preventive maintenance This appliance does not need any special maintenance. However, a few simple operations ha

Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY

Instructions for the user 22 9. PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should

Introduction THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING

Instructions for the installer 6 2. POSITIONING OF THE HOB It is the law that all gas appliances are installed by authorised persons. Clearance

Instructions for the installer 7 Overall dimensions: location of gas and electrical connection points (all measures in mm). 30 CM HOB 70 CM

Instructions for the installer 8 REQUIREMENTS 1 Overhead clearances – (Measurement A) Range hoods and exhaust fans shall be installed in accordan

Instructions for the installer 9 2.3 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in

Instructions for the installer 10 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or ULPG (propane). Refer to page

Instructions for the installer 11 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown